What am I seeing here?  

  RSS
Infiltrator
(@infiltrator)
Eminent Member

I am having this problem with feathering on the side of each layer on the first layer.  Does anyone have any ideas what is causing it?  I am thinkng that the top issue might be bed contamination and the bottom one is that I still have the nozzle too low but I'm not sure?

Posted : 26/10/2020 9:20 pm
Nikolai
(@nikolai-3)
Noble Member

Hi. Adjust your Live-Z. Your nozzle is too close to the sheet on the first layer.

Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram...
Posted : 26/10/2020 9:26 pm
Infiltrator
(@infiltrator)
Eminent Member

@nikolai-r

Ok,  I have gone up from -1.700 to -1.610 and it looks like that.  Is it still too low?

Posted : 26/10/2020 10:10 pm
Nikolai
(@nikolai-3)
Noble Member

Looks already pretty nice. You can try to raise a little bit more. From now on it's more a personal preference.

Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram...
Posted : 26/10/2020 10:14 pm
karl-herbert
(@karl-herbert)
Famed Member

@ssmith

maybe you will find helpful information here:

https://forum.prusaprinters.org/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen....
Posted : 26/10/2020 10:19 pm
Share:

Please Login or Register