Notifiche
Cancella tutti

Need a manual  

  RSS
cdollins
(@cdollins)
Active Member
Need a manual

I have a Prusa MK2 upgraded to a 2.5.  I cannot load the filament because of a blockage in the hot end.  I need to take the extruder unit apart to get to the blockage.  I did not receive  a construction manual but looked on line to build the upgrade.  I did not make a copy of the manual.  I went into the archives and found a manual for the upgrade.  It is not the right manual.  My extruder unit has two holes on the top.  The online manual shows four holes and a tube.  How can I get a manual for my model?

 

Postato : 18/10/2020 5:25 pm
--
 --
(@)
Illustrious Member
RE: Need a manual

Maybe try contacting support via CHAT in the store pages.  A long wait, but someone usually answers.

Postato : 18/10/2020 6:30 pm
cdollins
(@cdollins)
Active Member
Topic starter answered:
RE: Need a manual

I found it online.  Thanks

Postato : 19/10/2020 5:12 pm
Condividi: