Notifications
Clear all

Almost finished assembling my i3 mk3s But...  

  RSS
perry.jonathan
(@perry-jonathan)
Active Member
Almost finished assembling my i3 mk3s But...

I'm at the final stages of assembly. As per instruction manual I connected the extruder cable bundle through the einsy case so that the nylon filament didn't protrude too far towards the motor wires. However, the E motor cable wasn't long enough to reach it spot on the board. Shortening the wrap gives enough cable to slot it in, but then the nylon filament sticks in the motor wires. Can the nylon filament be cut to size? 

Posted : 15/09/2019 11:36 am
Share: