Notifications
Clear all

Z-hop limited above 1mm?  

  RSS
David T.
(@david-t)
Noble Member
Z-hop limited above 1mm?

Looking into default profiles for Slic3r I found out that Z-hop (Lift Z) is limited to layers above 1mm. Does anybody know the reason?

Posted : 28/07/2016 5:47 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Z-hop limited above 1mm?

No, but I use it on the first layer (when I need it) so I don't knock anything over.

This is with KISS.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 28/07/2016 7:12 pm
Share: