Printer stops mid print  

Page 2 / 2
  RSS
Tim
(@tim-m30)
Illustrious Member

There are known defects in 3.8.x that cause odd positional problems while printing.  They probably can also affect printer state.  These defects are often avoided by simply disabling the filament sensor. 

It is always wise to get more than one opinion......
Posted : 22/11/2019 8:49 pm
fheatherz
(@fheatherz)
Eminent Member

@tim-m30

I'll try that.. Not even sure the filament sensor is useful when using octoprint, so will disable it and see if I can get through this print.. Just in case, not starting it until tomorrow - don't want it burning a hole in the print when not watching it. 🙂 

Posted : 22/11/2019 8:52 pm
Page 2 / 2
Share:

Please Login or Register