PETG adhession  

  RSS
marek.t7
(@marek-t7)
Eminent Member

I have big problem with PETG adhesion - mostly I have to use huge power for removing my printouts and twice I even damaged PEI sheet covering the heat bed. Is it possible to reduce the adhesion - e.g. using some kind of separation?

Posted : 11/02/2018 6:37 pm
aaron.s5
(@aaron-s5)
Noble Member

Prusa states in the manual that PETG will fuse to the PEI and requires a separator.

I use Windex (blue window cleaner) as my final clean before the print. It leaves a small film that is just enough to let PETG release but still stick well.

Others us glue stick.

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…...
Posted : 11/02/2018 6:43 pm
marek.t7
(@marek-t7)
Eminent Member

Thanks a lot.

Posted : 11/02/2018 7:07 pm
Share:

Please Login or Register