First power up/calibration - Filament failed to load. Wrong idler position. Replaced springs. FILAMENT LOADS!  

  RSS
BCnFrontiers
(@bc314)
New Member

Thanks to whoever indicated spring tension causing wrong idler position.  I replaced the Idler Tension Springs with a lighter spring and I seemed to be able to dial in the 'Sweet Spot' a bit easier than intimated by other posts. Not sure if this is the fix, but I have been able to calibrate first layer now (consistently loads filament).

Hope this helps!

BC

BC...
Posted : 22/10/2019 7:04 am
Share:

Please Login or Register