Notifications
Clear all

Printing problems  

  RSS
Darkshier
(@darkshier)
Active Member
Printing problems

After installing my new hot end, fan, and P.I.N.D.A. probe my printer started a fight with me and I am certainly losing. I ran XYZ Calibration and First Layer Calibration and had a successful print. I was attempting to dial it in better when it all went wrong. Using the newest Cura (4.something ) Hatchbox PLA, 200°C, 0.15mm layer height, 10% infill. It went from too low to way to high for no known reason.

Posted : 09/11/2019 11:16 pm
Darkshier
(@darkshier)
Active Member
Topic starter answered:
RE: Printing problems

Previous print bottom.

Posted : 09/11/2019 11:17 pm
Darkshier
(@darkshier)
Active Member
Topic starter answered:
RE: Printing problems

Previous print 

Posted : 09/11/2019 11:18 pm
Darkshier
(@darkshier)
Active Member
Topic starter answered:
RE: Printing problems

Previous print top

Posted : 09/11/2019 11:20 pm
Share: