Notifications
Clear all

Wizard setup failing, XYZ calibration failed  

  RSS
kornstate14
(@kornstate14)
New Member
Wizard setup failing, XYZ calibration failed

New to Prusa. Bought used MK2 i3 and updated firmware. tried running through wizard and am not able to complete wizard setuo due to “calibration point not reached”
or whatnot. This is allll new to me, coming from Creality and leveling 95% of the time, and printing 5% of the time. Firmware was easy enough to install, went from 3.0.6 to newest 3.2.x not sure which version it was for Rambo 1.3 board. Any help on what is making the XYZ calibration to fail?

Posted : 19/10/2020 4:32 am
Share: