Notifications
Clear all

Problem with Z level adjustment.  

  RSS
jszewczyk
(@jszewczyk)
New Member
Problem with Z level adjustment.

Hi,

After a few years of good working (mk2), I have a problem with Z level adjustment.

If I turn on my printer I always have information about tunning Z level. Printer remember last value of this parameter, but the nozzle is far from the bed.

Changing of firmware doesn't nothing change 🙁

Somebody had this issue?

Thanks!

This topic was modified 2 months ago 6 times by jszewczyk
Best Regards, Jacek...
Posted : 17/07/2021 3:06 pm
Antonio da Catania
(@antonio-da-catania)
Moderator
.

Not sure, just trying to guess here.

Have you checked if the plastic parts of the extruder are in good shape? (expecially the one with the PINDA support).

I once had such part severely skewed due to the heat (many ABS prints can affect the PETG parts)

Parlo italiano...but I'm not an expert....
Posted : 17/07/2021 3:59 pm
Share: