Layer shifting when using Prusa Slicer on I3 Mk2
 
Notifications
Clear all

Layer shifting when using Prusa Slicer on I3 Mk2  

  RSS
Antowas
(@antowas)
New Member
Layer shifting when using Prusa Slicer on I3 Mk2

Hello

Just seeing if anyone has his issue or a solution for it.  When I slice a file with Prusa Slicer and attempt to print it on my mk2, I always have a layer shift, sometimes multiple ones.  The same file sliced through Cura or S3D comes out fine.  See attached picture as an example.  Strangely, when I use Prusa Slicer for files on my Prusa mini they come out fine.  I don't recall changing any settings that would cause this.

Left print sliced with Prusa slicer, right print same file sliced with Cura

Posted : 07/05/2020 2:31 pm
heinrich
(@heinrich)
New Member
RE: Layer shifting when using Prusa Slicer on I3 Mk2

This has also happend to me.
I was suggested to formatting my sd card, and remember to stop the card before taking it out of my pc.
I haven't had the problem since. 

Posted : 15/05/2020 2:33 pm
Antowas
(@antowas)
New Member
Topic starter answered:
RE: Layer shifting when using Prusa Slicer on I3 Mk2

I shall try that.  Thanks for the help!

Posted : 15/05/2020 7:46 pm
heinrich
(@heinrich)
New Member
RE: Layer shifting when using Prusa Slicer on I3 Mk2

No problem 🙂

Posted : 16/05/2020 2:07 pm
Share: