Layer adhesion  

  RSS
EHeapes
(@eheapes)
New Member

Hello, I am struggling with poor layer adhesion. Is it poor quality filament or incorrect ambient temp or incorrect extruder temp? Or is it a combination of all the above or is it something else altogether? Any input on this would be greatly appreciated. I have good first layer adhesion, in fact I have trouble getting prints off the bed. All of the prints pull apart along the different layers and then there can be small areas were the layers hold together with great strength. Sometimes the print will look good but comes apart quite easily and other times the layers separate while it is still printing. Oh I have upgraded to 3.2.3. and have only been using Prusaslicer and used it's default profiles. 

 

Efrem

...
Posted : 20/02/2021 7:11 pm
cwbullet
(@cwbullet)
Illustrious Member

Layer adhesion or first layer adhesion?  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 20/02/2021 9:11 pm
bobstro
(@bobstro)
Illustrious Member

Without knowing your settings, we can only make blind suggestions. Save your part & settings off in a 3MF project file, zip it up, and attach it to a reply here so we can see your settings and make better suggestions.

My notes and disclaimers on 3D printing and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan...
Posted : 20/02/2021 9:17 pm
Share:

Please Login or Register