Notifications
Clear all
Front extruder fan no longer works properly after upgrade to 3.3.1
I just upgraded to 3.3.1 and now my front fan no longer starts when it should and the head temp resets itself to zero after a few seconds of heating
I get an error message on Pronterface
Extruder fan speed is lower then expected
// action:pause
I tried rolling back the upgrade but now I still get the same issue.
No problems prior to upgrade and no changes to the hardware.
I can manually start the fan from the printer control but I still get the same issues.
Any ideas
Posted : 12/08/2018 4:36 am