Notifications
Clear all

3.81/1.06 firmware seems to have issues  

  RSS
Shelby Teknologies
(@shelby-teknologies)
Active Member
3.81/1.06 firmware seems to have issues

I had printed this same object several times without any issues and had printed several items before updating the firmware but once I updated the firmware it seems the z lower is way off resulting in globbing after about 15 minutes.  I've disassembled and cleaned the nozzle several times but it continues to have filament get stuck in the nozzle and wont extract as if it blobs on the end and cools really quick.

I'm not sure if it is a zaxis issue or a proper filament load and unload issue but it doesnt happen with the previous firmware.

Posted : 25/12/2019 11:28 pm
Share: