Notifications
Clear all

Is it possible to print using Delrin  

  RSS
grabnerwg@gmail.com
(@grabnerwggmail-com)
Active Member
Is it possible to print using Delrin

Have used Delrin before, using long rods and cutting them on my lathe. Delrin works very well in the products I make.

Is it possible to use Delrin filament on the Mini?

 

Walter

 

This topic was modified 4 years ago by [email protected]
Posted : 05/06/2020 7:24 pm
GrimmWinters
(@grimmwinters)
Trusted Member
RE: Is it possible to print using Delrin

i read delrin aka pom aka acetal needs a bed-temperature of 120°C, so probably no go with the mini as we can only heat up to a 100°C. but that's just what i read 🙂

Posted : 12/06/2020 10:19 am
Chocki
(@chocki)
Prominent Member
RE: Is it possible to print using Delrin

Here you go: https://gizmodorks.com/acetal-3d-printer-filament/

Normal people believe that if it ain’t broke, don’t fix it. Engineers believe that if it ain’t broke, it doesn’t have enough features yet.

Posted : 12/06/2020 12:02 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Is it possible to print using Delrin
Posted by: @grabnerwg

Have used Delrin before, using long rods and cutting them on my lathe. Delrin works very well in the products I make.

Is it possible to use Delrin filament on the Mini?

 

Walter

 

if you need good friction characteristics I would take a look at this filament: https://www.filamentworld.de/shop/special-filament/abriebfestes-filament/igus-iglidur-i-180-filament-1-75-mm-weiss/

...easier to print as POM.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 12/06/2020 1:48 pm
Share: