Gaps between the start and end of layer (walls, 2 perimeters)
 
Notifications
Clear all

Gaps between the start and end of layer (walls, 2 perimeters)  

  RSS
Kate
 Kate
(@kate)
New Member
Gaps between the start and end of layer (walls, 2 perimeters)

Hello! I printed with a 0.6 nozzle and noticed, what there are gaps between the start and end of layers. I use Prusa Slicer with a preset for Prusa  Mini 0.6 nozzle. I can't understand, how to fix it. Something with a retraction?

Posted : 15/05/2020 8:08 am
Matteo Cristini
(@matteo-cristini)
Reputable Member
RE: Gaps between the start and end of layer (walls, 2 perimeters)

Hi! I'd like to help but honestly I don't know where to start here. Does it happen only with this particular model, or on every print? And how did it look in the slicer preview? Maybe try adjusting the layer seam setting... Looking forward to helping 🙂

Posted : 18/05/2020 2:30 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Gaps between the start and end of layer (walls, 2 perimeters)
Posted by: @miraghem

Hello! I printed with a 0.6 nozzle and noticed, what there are gaps between the start and end of layers. I use Prusa Slicer with a preset for Prusa  Mini 0.6 nozzle. I can't understand, how to fix it. Something with a retraction?

Try to lower the retraction value or set to 0. In order not to exceed the maximum feed volume, I would also reduce the printspeed.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 18/05/2020 4:56 pm
Kate
 Kate
(@kate)
New Member
Topic starter answered:
RE: Gaps between the start and end of layer (walls, 2 perimeters)

@matteo-cristini, @karl-herbert, thank you for your answers!

Today I started to print 4 pieces for one project. I want to try one by one setting on each piece. For the first one, I changed a volumetric speed from 15 to 11.5. Next will be a retraction setting.

Posted : 19/05/2020 4:17 pm
Share: