Blobs and lines on outside of a cylinder; MINIi+, PETG
 
Notifications
Clear all

Blobs and lines on outside of a cylinder; MINIi+, PETG  

  RSS
ctadlock
(@ctadlock)
New Member
Blobs and lines on outside of a cylinder; MINIi+, PETG

Any thoughts on what we be causing this? It is more noticeable when printing a cylinder. Happens on all models and prints.

  • Prusa Mini+
  • Prusament PETG
  • PrucaSlicer 0.20 Quality settings

 

Posted : 12/04/2021 2:03 am
Turro75
(@turro75)
Estimable Member
RE: Blobs and lines on outside of a cylinder; MINIi+, PETG

looks like the seam (blob while jump to the next layer). To be sure in prusaslicer change the seam from  Nearest to Rear or Aligned, if all blob are aligned then it is a seam.

other than this https://help.prusa3d.com/en/article/seam-position_151069  try adjusting it by "retraction on layer change"  in printer settings or in filament overrides.

 

Posted : 12/04/2021 10:51 am
fuchsr
(@fuchsr)
Famed Member
RE: Blobs and lines on outside of a cylinder; MINIi+, PETG

But don't hold your breath. On round objects where you can't hide the Z seam you're always going to have artifacts where the nozzle has to move up to start the next layer. Unless you can print the object in vase mode. 

Posted : 12/04/2021 2:33 pm
Share: