Notifications
Clear all
ASA - angled perimeters
Hi,
It took me quite a while to balance okay but fast print results with ASA. Actually, my settings (prusaslicer 2.3.2) do very well concerning layer bonding and layer build ups on larger perimeter runs with angles not more than about 30 degrees.
My problem now: as shown on the pictures, this cap design (which is about 38mm in diameter and 44 in height) doesn't print well at all. Is this trooping?? What and where should I start to tweak, please?
Ps.:
I print my ASA at 238°, in a pre-heated, closed compartment. Lowering the speed doesn't do a better job, extrusion with standard, extrusion multiplier on 1.04...
Thank you!
Posted : 14/09/2021 1:08 pm