Notifications
Clear all

X-Axis Home Wrong  

  RSS
K Koehler
(@k-koehler)
New Member
X-Axis Home Wrong

I have a print that is using the max size of my build plate but I can't print it because the X-axis home is to far to the right, about 3mm. I checked and redid the Z-axis assembly but that didn't help.  Is there a way to put in an offset for the X-axis?

I made a 3mm thick spacer to slide over the top X-axis rail and this adjusted the home temporarily.

KO

Posted : 26/03/2021 11:41 pm
Oxygen
(@oxygen)
Reputable Member
RE: X-Axis Home Wrong

4.3.1 or 4.3.2 beta

Mini with FW:4.4.1 + SuperPINDA + Bondtech Heatbreak + PC4-M8 couplers + 1 piece boden

Posted : 27/03/2021 9:35 am
K Koehler
(@k-koehler)
New Member
Topic starter answered:
RE: X-Axis Home Wrong

I have 4.3.1, which I recently upgraded to. A friend asked if I reran the calibration Wizard after I installed the upgrade, and I haven't.  Will that make a difference?

I just started printing and has been working fine otherwise.

Posted : 31/03/2021 2:59 am
Share: