Notifications
Clear all

SuperPinda and sensor info  

  RSS
octal
(@octal)
Active Member
SuperPinda and sensor info

I installed the SuperPinda on my Prusa Mini, and when I go in the Sensor Info menu, it shows:

 MINDA 0   (zero)   when I put a gap between SuperPinda and nozzle of about 1.15mm 

and 

MINDA 1  (one) when I put a gap between SuperPinda and nozzle of about 0.9mm  (or 0.8mm)

 

Hardware: PrusaMini (Septembre 2020)

Firmware version: 4.3.0-RC1+2691)

Does this mean that the SuperPinda is not used (not detected) when the gap is beyond 1mm ???

 

Regards

This topic was modified 3 years ago by octal
Posted : 10/01/2021 9:32 pm
Gordon W
(@gordon-w)
Reputable Member
RE: SuperPinda and sensor info

The sensor info is what the sensor is showing, not the number of sensors. So what you are seeing is normal, the bed is being detected as close to the sensor (sensor = 1) around 0.8 -1 mm above the bed. 

Posted : 12/01/2021 1:01 pm
octal liked
Share: