Prusa Mini+ has no connection to Astroprint or Computer
 
Notifications
Clear all

Prusa Mini+ has no connection to Astroprint or Computer  

  RSS
tomtim
(@tomtim)
New Member
Prusa Mini+ has no connection to Astroprint or Computer

Hi there,

My Prusa Mini + has not been working with astroprint since today. The Raspiberry gets no connection to the Prusa.

I played the firmware 4.3.2 on it again, but no connection. The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.

 

Any ideas ? Or is my Prusa damaged ? What can I do ? 

 

 

Posted : 20/08/2021 1:44 pm
fuchsr
(@fuchsr)
Noble Member

Not sure what you mean by

The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.

To upgrade the firmware on the Mini, put it on the USB stick and reboot. 

Posted : 20/08/2021 2:23 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Prusa Mini+ has no connection to Astroprint or Computer
Posted by: @tomtim

Hi there,

My Prusa Mini + has not been working with astroprint since today. The Raspiberry gets no connection to the Prusa.

I played the firmware 4.3.2 on it again, but no connection. The computer displays a RASPI, but a firmware update from the computer breaks off - Nothing Found.

 

Any ideas ? Or is my Prusa damaged ? What can I do ? 

 

 

"The Raspiberry gets no connection to the Prusa."

Have you connected the Mini Micro-USB port to one of the Raspi USB ports, selected the correct interface (dev/ttyAMA0 or dev/ttyUSB0....) and baud rate? Also see here: https://help.prusa3d.com/en/article/octoprint-configuration-and-install_2182

wbr,

Karl

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen....
Posted : 20/08/2021 3:29 pm
Share: