Mini Prusa -Pause GCode  

  RSS
metty
(@metty)
Active Member

So far I tried M601 and M25. Prusa Mini seams to ignore them.

M600 works but unloads filament, what I do not want.

Is there a gcode command does a similar thing like the pause Button on the Printer?

I did not found more here: https://www.help.prusa3d.com/en/article/prusa-specific-g-codes_112173

Best Answer by mrstoned:

I found a few threads on the forum;

https://forum.prusaprinters.org/forum/hardware-firmware-and-software-help/pause-m601-not-working/#post-298804

From github;

Finally I can confirm that M601 is implemented in latest FW 4.2.0-RC1. Please try it out and confirm it too 🙂

 

But will not work when using octoprint.

 

Reading further i found a change in for the next update.

https://github.com/prusa3d/Prusa-Firmware-Buddy/pull/1097/files

Posted : 14/01/2021 1:08 pm
mrstoned
(@mrstoned)
Estimable Member

Can you verify that the m601 ends up in the gcode after a reslice?

I tried right-clicking in the slicer on the + at a specific layerheight and it atleast puts the M117 message and row below M601 in the file.

Flsun QQ-s "pro". Tevo Nereus. Prusa Mini+ KIT on order....
Posted : 15/01/2021 9:12 pm
metty
(@metty)
Active Member

Thanks for the reply mrstoned. I changed my gcode manually, so it must be there. I did not see any reaction of the printer while passing the section. Since M600 works I guess there is no implementation for M601? Or is there another command? Would be nice if this would work...

Posted : 16/01/2021 11:18 am
mrstoned
(@mrstoned)
Estimable Member

I cant find anything regarding this in prusaslicer on their github either.

I dont have my mini yet so cant check a real prusaprint.

If it doesn't honor the pausecommand in gcode then i guess it would be a bug in either PS or firmware.

Flsun QQ-s "pro". Tevo Nereus. Prusa Mini+ KIT on order....
Posted : 16/01/2021 11:44 am
mrstoned
(@mrstoned)
Estimable Member

I found a few threads on the forum;

https://forum.prusaprinters.org/forum/hardware-firmware-and-software-help/pause-m601-not-working/#post-298804

From github;

Finally I can confirm that M601 is implemented in latest FW 4.2.0-RC1. Please try it out and confirm it too 🙂

 

But will not work when using octoprint.

 

Reading further i found a change in for the next update.

https://github.com/prusa3d/Prusa-Firmware-Buddy/pull/1097/files

Flsun QQ-s "pro". Tevo Nereus. Prusa Mini+ KIT on order....
Posted : 16/01/2021 12:05 pm
metty
(@metty)
Active Member

Nice.. The new firmware did it:
M601 works with 4.2.1

Tanks for the help!

Posted : 16/01/2021 12:11 pm
Share:

Please Login or Register