Notifications
Clear all

[Solved] Mini Not Extruding After Resume  

  RSS
AgentNoise
(@agentnoise)
Eminent Member
Mini Not Extruding After Resume

Firmware 4.1

After resuming a print from octoprint extrusion stops.  I am setting the temp before resuming the print. The resume GCode below executes, including the extrusion G1, but after it moves into place it sits for a few seconds then starts moving but is not extruding.  Any ideas on what causes that?

G91
G1 E50
G1 Z-30 F300
G90

Best Answer by AgentNoise:

I figured it out.  Had to add M83 to the end of the resume gcode to set it back to relative mode.

This topic was modified 1 year ago by AgentNoise
Posted : 22/07/2020 2:37 am
AgentNoise
(@agentnoise)
Eminent Member
Topic starter answered:
RE: Mini Not Extruding After Resume

I figured it out.  Had to add M83 to the end of the resume gcode to set it back to relative mode.

Posted : 22/07/2020 5:59 pm
Share: