Notifications
Clear all

extruder has died on my mini  

  RSS
AZ_TIM
(@az_tim)
Trusted Member
extruder has died on my mini

my extruder has died. changed filaments, was re-printing first layer calibration, there was a popping noise and the screw with the spring under the feed tube to the extruder popped out. I cannot get it to stay screwed in for any length of time now. I can print a little while and then it stops extruding and the screw is popped out again. it's like there are no threads holding it in place.

I'm not a mad scientist, I'm an angry engineer in training.

Opublikowany : 19/06/2020 3:59 pm
AZ_TIM
(@az_tim)
Trusted Member
Topic starter answered:
RE: extruder has died on my mini

where can I find the chat option for support? I can't see it anywhere...

I'm not a mad scientist, I'm an angry engineer in training.

Opublikowany : 19/06/2020 4:08 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: extruder has died on my mini

@tlovern

Login with your Prusa account - select eshop and wait some seconds. A chat wondow will appear on the right bottom. I would recommend to deactivate all your add blocker.

good luck!

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Opublikowany : 19/06/2020 4:31 pm
AZ_TIM
(@az_tim)
Trusted Member
Topic starter answered:
RE: extruder has died on my mini

@karl-herbert

thanks!

I'm not a mad scientist, I'm an angry engineer in training.

Opublikowany : 19/06/2020 4:47 pm
AZ_TIM
(@az_tim)
Trusted Member
Topic starter answered:
RE: extruder has died on my mini

resolved! - looks like the screw was not full engaged with the nut in the tension arm. and it pulled out. then the nut wasn't lined up properly and that was preventing me from getting it in completely.

 

took the screw out, lifted the arm, adjusted the nut, reassembled and I am printing again! the support chat was extremely helpful.

I'm not a mad scientist, I'm an angry engineer in training.

Opublikowany : 19/06/2020 6:09 pm
Tracy i Gordon W polubić
Share: