Notifications
Clear all

Creaky noise during X-Axis movements  

  RSS
Dimonstar
(@dimonstar)
Active Member
Creaky noise during X-Axis movements

Hello everyone!

My Prusa Mini has developed a distinct noise when moving X-Axis both manually and during prints. It’s coming from somewhere near the X Motor area but I can’t figure it out. Has anymore dealt with similar issue before?

Prints don’t seem to be affected..yet. I made sure that X motor pulley was tight as well as belt tension and all easy accessible screws were tight as well.
Attaching a video below. It sounds like plastic/belt might be rubbing on something or something inside x motor that could make that noise?

IMG_1493

This topic was modified 3 years ago by Dimonstar
Posted : 25/04/2021 3:18 am
Share: