Bed levelling does not correct fully....
I have been using the mini for a few months every print is fine but today I did a large print that was almost full width of the bed and I have noticed the right hand side of the bed it not correct, I would have assume the PINDA would have caught this and corrected it.
Its only the right hand side the calibration layers are correct and seem to stick.
If I was calibrating i would say the nozzle need to go lower but that will not work for the rest of the bed.
Why would the PINDA get this wrong?
Any suggestions?
----------------------------------------------------------------------------------------------------------------------------
Prusa Mini+ (Ordered Dec 19,2020 - Arrived Feb 21,2021) stated clicking Mar 2nd / MP Select Mini V2
RE: Bed levelling does not correct fully....
The reason is rather deep. A flaw in the bed level algorithm that doesn't take into account the full bed surface.
Look up Bed Level Correction. Not sure the Mini has it, but it's how I deal with the broken firmware that causes the issue.
RE: Bed levelling does not correct fully....
The reason is rather deep. A flaw in the bed level algorithm that doesn't take into account the full bed surface.
Look up Bed Level Correction. Not sure the Mini has it, but it's how I deal with the broken firmware that causes the issue.
interesting
----------------------------------------------------------------------------------------------------------------------------
Prusa Mini+ (Ordered Dec 19,2020 - Arrived Feb 21,2021) stated clicking Mar 2nd / MP Select Mini V2
RE: Bed levelling does not correct fully....
Look up Bed Level Correction. Not sure the Mini has it, but it's how I deal with the broken firmware that causes the issue.
It doesn't. For those of us with Mini+ that don't level correctly, we have no recourse. There is no fix.