Notifications
Clear all

Purge extruder message. What to do ?  

  RSS
GuusK
(@guusk)
Active Member
Purge extruder message. What to do ?

This topic was modified 2 years ago by GuusK
Posted : 20/12/2021 3:56 pm
GuusK
(@guusk)
Active Member
Topic starter answered:
RE: Purge extruder message. What to do ?

Prints fine but got this message when printing

Posted : 20/12/2021 3:57 pm
brumm
(@brumm)
Active Member
RE: Purge extruder message. What to do ?

No worries, this only a test line before the printer starts printing your 3d object.

Posted : 21/12/2021 9:25 am
GuusK
(@guusk)
Active Member
Topic starter answered:
RE: Purge extruder message. What to do ?

Yes only the message stay on during the hole print

Posted : 21/12/2021 9:36 am
brumm
(@brumm)
Active Member
RE:

I can see the filename during the print (MK3S+), in the last display line.

Maybe you like to write some more information like printer type, firmware version, PrusaSlicer version, print from sd / cable / octoprint, ...

Don't know if i can help, but possibly a more experienced user.

This post was modified 2 years ago by brumm
Posted : 21/12/2021 9:56 am
Neophyl
(@neophyl)
Illustrious Member
RE: Purge extruder message. What to do ?

Characters sent to the LCD are 'static'.  In that they are persistent unless something over writes them.  So a message wont clear unless a new message is written in its place (or blank spaces are written over it).

Posted : 21/12/2021 10:01 am
Share: