Notifications
Clear all

Where are the firmware updates?  

Page 3 / 3
  RSS
jaydubblazer
(@jaydubblazer)
Trusted Member
RE: Where are the firmware updates?

I never had any bed leveling issues, but had to monitor the filament change like a hawk.   Most of the time I sit there like I was fishing waiting for a bite.   As soon as the ramming was done I was ready to give it an extra tug if needed.  I was trying to multitask, got distracted and missed the unload sequence tonight.  To my surprise it was unloaded when I got back.  The 4.03 unload worked, and it loaded much easier as well.  Luck or firmware I’ll take it.

JayDub
Weened on MK3's at work, FrakenMini and MKs at home.

Posted : 14/02/2020 3:55 am
towlerg
(@towlerg)
Noble Member
RE: Where are the firmware updates?

@jaydubblazer

Interested to hear you are doing filament changes live on a Mini. Part of my requirement for a 3d printer was the ability to print front panels with embedded coloured lettering, and I was torn whether the bowden on the Mini would make that problematic.

This post was modified 4 years ago by towlerg
Posted : 14/02/2020 12:44 pm
jaydubblazer
(@jaydubblazer)
Trusted Member
RE: Where are the firmware updates?

I just did my 2nd successful filament change.  so far so good.

JayDub
Weened on MK3's at work, FrakenMini and MKs at home.

Posted : 14/02/2020 2:11 pm
Crawlerin
(@crawlerin)
Prominent Member
RE: Where are the firmware updates?

Good to hear, I never managed to change filament once. I may flash it and give it a try.

Posted : 14/02/2020 4:01 pm
jaydubblazer
(@jaydubblazer)
Trusted Member
RE: Where are the firmware updates?

I just forgot to cut the end off my filament and didn't get the extruder to bite.  I trimmed it, stuck back in and hit purge about 8 times until I got filament.  Assuming that not trimming the filament was my fault this will make three in a row.  some kind of record I'm sure.

 

Now they need to get the M601 and M602 working.

JayDub
Weened on MK3's at work, FrakenMini and MKs at home.

Posted : 14/02/2020 4:10 pm
Page 3 / 3
Share: