Notifications
Clear all

trapezoidal spindle is wobbling.... normal?  

  RSS
Landvogt
(@landvogt)
Eminent Member
trapezoidal spindle is wobbling.... normal?

Is it normal for the trapezoidal spindle to wobble a little? Or must the concentricity fit exactly?

Can you observe well when the Z axis moves from top to bottom ...

Also had a problem in the meantime, which was present in the lower third of a loud squeak. A loosening and retightening of the screws of the Z-axis has solved this problem.

Posted : 15/03/2021 6:48 pm
Clarmrrsn
(@clarmrrsn)
Honorable Member
RE: trapezoidal spindle is wobbling.... normal?

It may be slightly bent, I would suggest speaking to prusa chat support on the EShop.

This post was modified 3 years ago by Clarmrrsn

Tank you very much!

Posted : 15/03/2021 7:04 pm
Share: