Notifications
Clear all

Temperature override  

  RSS
Daryl
(@daryl-2)
Trusted Member
Temperature override

Question: When using the front panel (Mini+) to adjust the nozzle temperature, the override only lasts until the next GCODE command that sets it to something else?  I notice if I override right before printing starts, it works for first layer but then reverts after that.

Posted : 04/02/2021 7:15 pm
fuchsr
(@fuchsr)
Famed Member
RE: Temperature override

Correct. If you have different temps for first layer, you'll have to wait for it to finish if you want to change the temperature for the rest of the model.

Posted : 06/02/2021 12:04 pm
Daryl liked
Share: