Notifications
Clear all

Restarting a print after a power outage?  

  RSS
cobraboy3000
(@cobraboy3000)
New Member
Restarting a print after a power outage?

I tripped a breaker in my apartment (its very hot in Texas right now! A/c and fans are running full blast…) Is there a way to restart printing from where i left off? Any help is appreciated!
 
Prusa Mini+

Posted : 27/07/2021 12:16 am
BogdanH
(@bogdanh)
Reputable Member

This can be done in certain situations, but result depends on quite a lot of things. That is, it may happen you're able to finish the print, but final print won't be that robust (layer binding) and/or will have visual impact. Because one can't predict the result, it's questionable if it's worth.. at the end you might decide to make a new print anyway -and in that case we lose filament and time.
You can get some ideas in this video.

Mini+ with Bondtech upgrade & modified firmware...
Posted : 27/07/2021 7:18 am
cobraboy3000
(@cobraboy3000)
New Member
Topic starter answered:
thanks

thanks... 👍 just watched it all... will definitely use the info in the future

Posted : 27/07/2021 10:25 pm
Share: