PSA: Don't try to push stuck filament in PTFE tube with another filament
 
Notifications
Clear all

PSA: Don't try to push stuck filament in PTFE tube with another filament  

  RSS
Pitel
(@pitel)
Eminent Member
PSA: Don't try to push stuck filament in PTFE tube with another filament

...because the stuck filament might push the new one on the side of the PTFE tube and penetrate it.

So don't be dumb/lazy like me, and unscrew the tube and remove it by hand. 👍

Posted : 29/09/2020 9:39 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: PSA: Don't try to push stuck filament in PTFE tube with another filamentjbjhk

That is bed luck.  I do this all the time without issue.  I even use a tungsten rod.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 29/09/2020 10:04 pm
Share: