Notifications
Clear all

[Solved] Program crashes during slicing  

  RSS
Fitz
 Fitz
(@fitz)
Active Member
Program crashes during slicing

Every time I try to slice a model after setting up an stl for the Mini the program crashes. No error codes or notices. What's wrong?

Posted : 06/01/2020 8:24 pm
Area51
(@area51)
RE: Program crashes during slicing

Do the model have any errors and if so, did you repair them before slicing.

Errors to PrusaSlicer can be reported as issues here on GitHub: https://github.com/prusa3d/PrusaSlicer/issues

Have a look at my designs on PrusaPrinters ;)...
Posted : 06/01/2020 11:33 pm
Fitz
 Fitz
(@fitz)
Active Member
Topic starter answered:
RE: Program crashes during slicing

Everything looks ok before slicing.

Posted : 07/01/2020 2:27 pm
Area51
(@area51)
RE: Program crashes during slicing

Is it the specific model or all STL models?

Which version of PrusaSlicer (PS) is it, OS?

Have you tried to reinstall the program (reset setup)?

Have a look at my designs on PrusaPrinters ;)...
Posted : 07/01/2020 4:08 pm
Fitz
 Fitz
(@fitz)
Active Member
Topic starter answered:
RE: Program crashes during slicing

@area51

All .stl files.

2.1.1 win64.

Have tried reinstall.

Posted : 07/01/2020 10:00 pm
Area51
(@area51)
RE: Program crashes during slicing

Is it only when slicing to the Mini or also when slicing to other models?

You could try the latest 2.2.0 Alpha version - It is fairly stable and I use it over 2.1.1 now.

Have a look at my designs on PrusaPrinters ;)...
Posted : 08/01/2020 1:12 pm
Fitz
 Fitz
(@fitz)
Active Member
Topic starter answered:
RE: Program crashes during slicing

@area51

Using 2.2.0 I get message "unable to enumerate device". Whats up?

This post was modified 2 years ago by Fitz
Posted : 13/01/2020 2:53 pm
Area51
(@area51)
RE: Program crashes during slicing

An error like "unable to enumerate device" could point to an USB device or Graphic card. I would guess that it could be an USB as the new Alpha release tries to locate USB devices (memory sticks) when exporting the generated G-code.

That is properly not helpful - I would report it as an issue on GitHub and hope the Prusa developers have an answer.

PrusaSlicer GitHub issues: https://github.com/prusa3d/PrusaSlicer/issues

Have a look at my designs on PrusaPrinters ;)...
Posted : 13/01/2020 11:31 pm
Share: