Pause print G-code ignored during print on Prusa MINI?  

Page 2 / 2
  RSS
Gordon W
(@gordon-w)
Reputable Member

Apologies all, looks like I had a bit of a 'senior moment' and got confused between the two bugs.

(edit to add that I was going to edit my previous post to show it should be ignored, but the edit time on the forum site is too short and I can no longer edit the posts!)

This post was modified 6 months ago by Gordon W
Posted : 08/07/2020 5:42 pm
Orbus
(@orbus)
New Member

Prusa mini with 4.1.0 firmware. My print just ignored the pause so the bug is definitely still there.

Posted : 07/08/2020 12:17 pm
Gordon W
(@gordon-w)
Reputable Member

Pause when printing from USB is reported as fixed in latest (4.2.0) firmware, but currently doesn't work if printing from Octoprint.

Posted : 07/08/2020 12:37 pm
Orbus
(@orbus)
New Member

Oh, I've missed the latest firmware. My bad!

Posted : 07/08/2020 12:40 pm
SuperheroDIY
(@superherodiy)
Active Member

Running 4.2.1 on my Prusa MINIs, it just skipped over the pause gcode on a print where I was going to embed magnets. SUPER surprising since the MK3S did it perfectly, but obviously a bug in the firmware that Prusa maybe doesn't care about? I'll bug their support about it ...

Posted : 30/10/2020 3:35 am
Gabi
(@gabi-2)
Active Member

Currently the M601 is supported on a partial way, it is only supported by USB, from Octoprint is not supported, it doesn't do any pause and from the USB the message that the prusa slicer has requested to you never appears in the screen, so I think is only partially fixed.

Posted : 18/11/2020 6:40 pm
SuperheroDIY
(@superherodiy)
Active Member
Posted by: @gabipallares

Currently the M601 is supported on a partial way, it is only supported by USB, from Octoprint is not supported, it doesn't do any pause and from the USB the message that the prusa slicer has requested to you never appears in the screen, so I think is only partially fixed.

I'm not sure if you're saying that the M601 should have worked via USB or not -- but it definitely doesn't work on USB. It didn't pause at all when printing via USB, just skipped right past and finished the print.

Posted : 18/11/2020 7:25 pm
Gordon W
(@gordon-w)
Reputable Member

There was an update to the code today ( https://github.com/prusa3d/Prusa-Firmware-Buddy/pull/1097 ) but the title "fix stop print when paused" doesn't give a lot of detail as to what problem if fixes! Hopefully there will be a release candidate build of 4.3 soon and we'll find out what it fixed!

 

Posted : 27/11/2020 4:58 pm
cwbullet
(@cwbullet)
Famed Member

@gordon-w

Great news.  The inability to pause a print is annoying.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 27/11/2020 6:04 pm
Gordon W
(@gordon-w)
Reputable Member

@cwbullet

I advise a little caution before celebrating 😀 the title of the pull request could cover any number of scenarios, and it may not be for this problem, but here's hoping!

Posted : 27/11/2020 7:46 pm
Page 2 / 2
Share:

Please Login or Register