Notifications
Clear all
Has anybody tested the maximum volumetric throughput of the Mini
I'm probably going to wait for a Mini once the initial rush dies down. It just occurred to me that it uses a different hotend than the Mk3, so the maximum volumetric rate of the hotend is unknown. I'm curious what the limits of this device are other than just size. Has anybody tested the maximum volumetric rate (to be used in PrusaSlicer's Maximum volumetric speed setting) yet? Is Prusa still using 15mm^3/s as their (optimistic IMO) rate?
Posted : 14/02/2020 6:11 pm
MattJMurphy liked