Tuning the PC Blend Carbon Fiber profile
 
Notifications
Clear all

Tuning the PC Blend Carbon Fiber profile  

  RSS
imhavoc
(@imhavoc)
Active Member
Tuning the PC Blend Carbon Fiber profile

I was getting some serious over extrusions from the PC CF using the Prusa Slicer default "Prusament PC Blend Carbon Fiber" profile, so I ran a series of vase-mode cubes to tweak the extrusion multiplier. After several iterations, I ended up at *0.7* for an extrusion multiplier.

I think I went too far. Because of the textured surface of the CF, I think I need to factor in some kind of "surface coefficient."

I was wondering if anyone else has made adjustments to the profile.

Best Answer by Swiss_Cheese:

I'd love to help you out, but apparently you bought to only roll that was available, for the month. I heard a rumor that that Prusa was going to make another roll available in October, so maybe whoever gets that roll will be able to help you out. 

 

Good Luck

 

Swiss_Cheese

Posted : 22/09/2021 2:34 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member

I'd love to help you out, but apparently you bought to only roll that was available, for the month. I heard a rumor that that Prusa was going to make another roll available in October, so maybe whoever gets that roll will be able to help you out. 

 

Good Luck

 

Swiss_Cheese

The Filament Whisperer...
Posted : 22/09/2021 10:38 pm
sergey and imhavoc liked
imhavoc
(@imhavoc)
Active Member
Topic starter answered:
LOL

😆

Posted : 22/09/2021 10:50 pm
Share: