Notifications
Clear all

Prusa mk3s+ Z behavior  

  RSS
Kopplog
(@kopplog)
Estimable Member
Prusa mk3s+ Z behavior

Hi

It would be great if the z-axis of the mk3+ raise much higher by standard after telling 'em "stop print".

Otherwise the extruder-section will be in the way... So, I'll always will have to go into sub-menus to raise the z via settings>move axis>move z>...

 

Thx for your time, k

 

Best Answer by Lichtjaeger:

You don't need to go to sub-menus. Just hold the button to enter the Z-movement screen.

Posted : 15/07/2021 11:56 am
Lichtjaeger
(@lichtjaeger)
Noble Member
a

You don't need to go to sub-menus. Just hold the button to enter the Z-movement screen.

Posted : 15/07/2021 12:03 pm
Share: