Notifications
Clear all

Problem Modeling PTFE Fitting Thread  

  RSS
Smiledemons
(@smiledemons)
Active Member
Problem Modeling PTFE Fitting Thread

Hello guys, I am trying to make adjustments to the filament drybox and add an attachment for PTFE fitting.
https://blog.prusaprinters.org/dryboxes-and-alternative-spool-holders-not-only-for-multimaterial-upgrade/
As my understanding, the PTFE fittings are M10x0.9 and M6x1.0, which I am trying to model in Inventor with CoolOrange thread generator.

Inventor does not allow me to model M10x0.9, and the M6x1.0 I was able to make was really tight so I couldn't insert the fitting all the way.
Does anyone have any suggestions on how I can model these threads? I do not mind using other software. The shape I am trying to make is really simple.

Thanks in advance!

Posted : 11/12/2019 11:40 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Problem Modeling PTFE Fitting Thread

good morning, the Pitch on a screw thread normally increases as the diameter increases, 
M6 threads have a Pitch of 1.0mm 
M10 threads have a pitch of 1.5mm

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 12/12/2019 10:00 am
Share: