Printer has no input
I have not been able to use a SD card almost since the start. I used the included card, then added some files to the card. When I put the card back in I got a blank screen with boxes in the middle. I tried formatting a new card and got the same display. The printer worked fine without a card in the slot.
I was using my computer to print things and one day I got problems with that. Now I get nothing when I click Print. I have tried a few times and gave up.
Best Answer by fuchsr:
Sounds like a hardware problem. In a case like this, I'd get on a chat with Prusa Support, especially if your printer was still under warranty. Go to https://shop.prusa3d.com/, log into your account, and then click on the Chat button in the lower right corner.
Sounds like a hardware problem. In a case like this, I'd get on a chat with Prusa Support, especially if your printer was still under warranty. Go to https://shop.prusa3d.com/, log into your account, and then click on the Chat button in the lower right corner.
The SD card slots/readers on both of my MK3s are flakey and frequently are not recognized and read. Pulling them out partially and wiggling a bit usually fixes it, but I'm always worried that shaking and vibration during a print will cause it to lose contact and halt the print, but it hasn't happened yet.
Hear ye, Hear ye! Step right up folks and get your Government salvation here! Less than $.002 per word! Amazon.com/dp/B0B8XMMFP4