Phaetus Dragonfly (BMO) - my experience
 
Notifications
Clear all

Phaetus Dragonfly (BMO) - my experience  

  RSS
Kopplog
(@kopplog)
Trusted Member
Phaetus Dragonfly (BMO) - my experience

Before I start... 

No, I haven't run that heatsink. I return it, before risking not being able to return it as unused/brand new.

The reasons:

  1. Bad (not complete) installation guides to be found worldwide and no videos to be found.
  2. The BMO version with its collet-clip it didn't fit into the Mk3(all) flange... and I again, I couldn't find any information on that issue...
  3. I wasn't able to find out which TPFE-tube and in which dimension should fit through the collet. Also, no information whatsoever on that issue. 
  4. It came without any TPFE-tube, although there were (lots of) spare parts/ wrenches included (which is good). 

That's all... happy to read your thoughts on this... 

 

Posted : 25/11/2021 3:58 pm
cwbullet
(@cwbullet)
RE: Phaetus Dragonfly (BMO) - my experience

When you say TPFE are you meaning PTFE?  

Posted by: @kopplog

Before I start... 

No, I haven't run that heatsink. I return it, before risking not being able to return it as unused/brand new.

The reasons:

  1. Bad (not complete) installation guides to be found worldwide and no videos to be found.
  2. The BMO version with its collet-clip it didn't fit into the Mk3(all) flange... and I again, I couldn't find any information on that issue...
  3. I wasn't able to find out which TPFE-tube and in which dimension should fit through the collet. Also, no information whatsoever on that issue. 
  4. It came without any TPFE-tube, although there were (lots of) spare parts/ wrenches included (which is good). 

That's all... happy to read your thoughts on this... 

 

 

--------------------
Chuck H
3D Printer Review Blog...
Posted : 09/12/2021 11:17 am
Kopplog
(@kopplog)
Trusted Member
Topic starter answered:
RE: Phaetus Dragonfly (BMO) - my experience

PTFE 

Posted : 09/12/2021 2:40 pm
Share: