Avisos
Vaciar todo

MMU2 and gcode from prusaprinters  

  RSS
Street54
(@street54)
New Member
MMU2 and gcode from prusaprinters

I just added the MMU2 to my MK3S and I have a question. Can I still use gcode that was uploaded to prusaprinter? Or do I need to reslice it since I have the MMU? I want to print the LACK enclosure parts, but I was not sure if I needed to reslice them or not.

talktowendys
Respondido : 25/11/2020 5:40 am
ChristieLeeEMT
(@christieleeemt)
Active Member
RE: MMU2 and gcode from prusaprinters

I don't have the MMU, so I don't know, but since slicing only takes a couple minutes, maybe just re-slice to be safe?

Respondido : 29/11/2020 12:38 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: MMU2 and gcode from prusaprinters

If you use the load to nozzle feature, and load your preferred filament to the nozzle, then you can use standard Mk3 Sliced models as if the MMU was not there

If you disconnect the MMU and feed the filament directly into the extruder, you will not be able to use the filament out sensor capability, but otherwise you can treat it as a Mk3

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Respondido : 29/11/2020 1:41 am
Compartir: