Notifications
Clear all

Mk3S Cable Strain Relief?  

  RSS
muddymaker
(@muddymaker)
Trusted Member
Mk3S Cable Strain Relief?

Does anyone know where I can purchase a replacement cable strain relief that is used in the back of the extruder that goes to the Einsy case on the MK3S? Or perhaps a suitable alternative as a replacement?

Posted : 19/01/2021 3:54 am
loadinglevelone
(@loadinglevelone)
Trusted Member
RE: Mk3S Cable Strain Relief?

1. You can print one yourself. All 3D models are available from here: https://www.prusa3d.com/prusa-i3-printable-parts/
2. Or you can buy spare parts from the official Prusa store: https://shop.prusa3d.com/en/36-plastic-parts

This post was modified 3 years ago by loadinglevelone

My printers: Mk3s / Mk3s clone with +upgrdaes (you know SPinda and all that good stuff) / Mini+ / Ender 3 v2

Posted : 19/01/2021 6:31 pm
muddymaker
(@muddymaker)
Trusted Member
Topic starter answered:
RE: Mk3S Cable Strain Relief?

I think it’s a piece of nylon that’s either 3mm or 4mm in diameter. Does anyone know how long it’s meant to be? 

Posted : 19/01/2021 7:58 pm
Dan Rogers
(@dan-rogers)
Noble Member
RE: Mk3S Cable Strain Relief?

It's 50 cm long (19.7 inch) = per assembly manual step 55, page 80

Posted : 19/01/2021 9:44 pm
cwbullet
(@cwbullet)
Member
RE: Mk3S Cable Strain Relief?

I would love to find a way to make the cables do up instead of back.  Thermistor wires are fragile.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 20/01/2021 1:58 am
Share: