Mk3S Cable Strain Relief?
Does anyone know where I can purchase a replacement cable strain relief that is used in the back of the extruder that goes to the Einsy case on the MK3S? Or perhaps a suitable alternative as a replacement?
1. You can print one yourself. All 3D models are available from here: https://www.prusa3d.com/prusa-i3-printable-parts/
2. Or you can buy spare parts from the official Prusa store: https://shop.prusa3d.com/en/36-plastic-parts
I think it’s a piece of nylon that’s either 3mm or 4mm in diameter. Does anyone know how long it’s meant to be?
It's 50 cm long (19.7 inch) = per assembly manual step 55, page 80