Is it recommended to put the PSU, LCD panel and filament outside the enclosure?
 
Notifications
Clear all

Is it recommended to put the PSU, LCD panel and filament outside the enclosure?  

  RSS
prusanewuser
(@prusanewuser)
Prominent Member
Is it recommended to put the PSU, LCD panel and filament outside the enclosure?

Hi, if printing PLA and PETG, which components are recommended to put outside the enclosure?

Posted : 10/07/2020 2:34 pm
cwbullet
(@cwbullet)
Member
RE: Is it recommended to put the PSU, LCD panel and filament outside the enclosure?

PSU yes.  My LCD is in the enclosure, but I think both depend on the temperature of your enclosure.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 11/07/2020 1:25 am
Share: