Notifications
Clear all
How to have different support properties at different layers?
Hi, currently I use "Support on build plate only". I want to assign different support parameters to certain layers. I followed the guide below and created a range. However, when I clicked on the gear icon->Add Settings->Support Material, nothing shows up to allow me to change the support parameters even under Expert mode. Can you please tell me how to do it? I am happy with the Support Material Interface between the build plate and the model. However, I am not happy with the one in the middle of the model where there are overhang due to fillet (shown in blue). I want to increase the Support Material Interface in those layers.
Posted : 29/08/2020 10:39 pm