Notifications
Clear all

hotend  

  RSS
Barry Windsor
(@barry-windsor)
Active Member
hotend

I have been having a lot of problems with nozzle blocking.

In the course of removing the nozzle to clean I have broken the heater cable from the block. Is it possible to reconnect the cable or is a new hotend needed?

If new hotend is needed how do I find part number?

Thanks for your help!

Napsal : 17/11/2019 10:44 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: hotend

You only really need a new heater.   BUT the screw holding the heater in place  is often difficult to loosen, 

the manufacturers E3D, sell a sock and block pack

https://e3d-online.com/block-sock-v6-upgrade-kit

Heaters 
https://e3d-online.com/standard-heater-cartridge

the Mk3 uses a 24 volt 40 watt heater
the Mk2 and Mk2.5 use a 12 volt heater... MAKE SURE THAT YOU GET THE RIGHT ONE    if you put the wrong heater in a Mk3, it will try and pull 160 watts, and will wither melt something you don't want melting, blow a fuse or burn out quickly...   the wrong voltage in a mk2 or 2.5 and you will not be able to achieve the temperatures you need to print! 

It's always a good idea to have a spare thermistor as well   (the wires are very fragile)  I suggest you get at least one, as there is a chance that you will damage the thermistor wires whilst trying to replace the heater

https://e3d-online.com/prusa-mk2-mk2s-hotend-spares

If all else fails...  you can get a complete hot end
https://e3d-online.com/prusahotend

E3D have resellers in various locations 
https://e3d-online.com/resellers

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 17/11/2019 2:16 pm
Barry Windsor
(@barry-windsor)
Active Member
Topic starter answered:
RE: hotend

Hi Joan,

Thanks very much for your reply.

Heater and thermistor ordered!

Didn’t realise there was a UK supplier.

Regards,

Barry.

Napsal : 17/11/2019 2:36 pm
Neophyl
(@neophyl)
Illustrious Member
RE: hotend

E3D which makes the hotends is a UK company.  Bit a bit weird if they weren't available in the UK 🙂

Napsal : 17/11/2019 4:32 pm
Barry Windsor
(@barry-windsor)
Active Member
Topic starter answered:
RE: hotend

Thanks very much.

Ordered!

Napsal : 17/11/2019 4:45 pm
rmm200
(@rmm200)
Noble Member
RE: hotend

In my book, parts from E3D are as recommended as getting them directly from Prusa.

And a heck of a lot cheaper on shipping.

Doubly nice in the states - E3D has a good selection on Amazon. Two day free shipping with Prime.

Napsal : 17/11/2019 5:21 pm
Share: