Fillamentum flexfill 98A
How does one remedy filament sticking to filament on the roll? This seems to happen mostly to the fillamentum 98A. The filament prints fine. When not in use they are stowed within the bags they where shipped and the disilicate packet. I thought perhaps the humidity might be causing this but after drying the spool out in an oven for several hours the filament still stuck when the printer advanced. I have been unwinding and rewinding the spool during print jobs but there must be another solution.
RE: Fillamentum flexfill 98A
I have no experienced this. How are you storing the rolls before you print?
--------------------
Chuck H
3D Printer Review Blog
RE: Fillamentum flexfill 98A
I've got some of this to try so sorry can't help but bookmark this thread to see if same problem occurs, currently its unopened but like you I am planning on keeping it in the shipping bag.
RE: Fillamentum flexfill 98A
@cwbullet
When not in use they are stowed within the bags they where shipped and the disilicate packet.