Extrudr XPETG Matte - any experience/tips with this filament?
 
Notifications
Clear all

Extrudr XPETG Matte - any experience/tips with this filament?  

  RSS
Sp4rkR4t
(@sp4rkr4t)
Estimable Member
Extrudr XPETG Matte - any experience/tips with this filament?

I've been looking for more matte filaments lately as they are far preferred in our house and while I have a selection of matte PLA already finding a more workhorse filament that prints well in a matte finish is proving difficult. Today I found out about Extrudr's Matte XPETG and was wondering if anyone has experience using it and if it has any quirks or does it print like normal PETG?

 

Also if anyone knows of any other matte PETG style filaments I should look into?

Posted : 10/01/2022 2:02 pm
cwbullet
(@cwbullet)
Member
RE: Extrudr XPETG Matte - any experience/tips with this filament?

I would start with Prusament and adjust the settings to get it perfect.  I had a sample and cannot remember the final settings but it was nto far off from Prusament.  I think I only adjusted the temperature.   

--------------------
Chuck H
3D Printer Review Blog

Posted : 10/01/2022 3:44 pm
Sp4rkR4t
(@sp4rkr4t)
Estimable Member
Topic starter answered:
RE: Extrudr XPETG Matte - any experience/tips with this filament?

Ah thanks for the pointers, did the sample print well and is the matte finish good?

Posted : 10/01/2022 3:51 pm
cwbullet
(@cwbullet)
Member
RE: Extrudr XPETG Matte - any experience/tips with this filament?

It is decent.  I think I remember printing at a slightly lower temp to get better Matte but it could have been higher.  That was before I kept a notebook.  

Posted by: @sp4rkr4t

Ah thanks for the pointers, did the sample print well and is the matte finish good?

 

--------------------
Chuck H
3D Printer Review Blog

Posted : 10/01/2022 3:57 pm
Sp4rkR4t liked
kennedystewart
(@kennedystewart)
New Member
RE: Extrudr XPETG Matte - any experience/tips with this filament?

Extrudr XPETG MATT has a unique matte surface and is more thermally resistant and harder than standard PETG. It is ideal for mechanical stress

drift boss

Posted : 11/01/2022 1:28 am
Share: