Duh Moment
I hope you all feel my pain. I was printing last night and just could not get my printer dialed in. Too low and then too low.
I finally went to bed disgruntled. I realized this morning what the problem was......DUH! Scrap of print on the magmatic print bed under the sheet. Boy did I feel stupid. I hope this adds to you things to check and spares you of a wasted evening.
--------------------
Chuck H
3D Printer Review Blog
RE: Duh Moment
Yes, I have that T shirt too!
Just wait til we have bed randomization in firmware so it won't be obvious that the problem is localized.
RE: Duh Moment
@bobstro
Probably true. It really hurts when you realize how stupid a mistake is after it has cause hours wasted to try get something to work.
--------------------
Chuck H
3D Printer Review Blog
RE: Duh Moment
The bed mesh leveling gives you a clue when that has happened. A scrap of interface could blow onto the bed when you've got the sheet off - but bed mesh leveling does one of those whoop-de-doos when that has happened (unexpected bump detected on print surface)
RE: Duh Moment
@dan-rogers
It did not do that this time, but I have seen it.
--------------------
Chuck H
3D Printer Review Blog