Diagonal lines on the top surface  

  RSS
prusanewuser
(@prusanewuser)
Honorable Member

Hi, I have monotonic infill for the top layer and set HopZ to 2-5mm. However, there are still diagonal lines on the top surface. How come? Some of them are tangential to circular holes and some of them are from nowhere. I then turned on Ironing but I can still see those lines. Is there any way to get rid of them completely? Also, when I turned on ironing, I often see burnt marks. What are the recommended parameters? I have tried 5-25% flow and the rest are default values. 

This topic was modified 2 months ago by prusanewuser
Posted : 12/02/2021 2:16 pm
Dan Rogers
(@dan-rogers)
Reputable Member

as they say in Boston - Piktcha???

 

Posted : 16/02/2021 3:16 am
Share:

Please Login or Register